Easy DIY IKEA Kura Bed Hack

No 1 Easy DIY IKEA Kura Bed Hack Offline App & Easy To Use

We was ready to move from his crib to a big kid bed. But we needed his crib for Maggie, so we didn’t do the usual thing where you can turn the crib into a toddler bed. We went straight to a twin and just ripped off the bandaid. And he did great. For a kid who sometimes balks at change, I have to say, we couldn’t have hoped for any better transition. I think it’s partly because we got him a really fun bed from IKEA, and partly because we let him help us put it together. Since then, I’ve been meaning to add a little hack to it to make it even more custom, and we finally got around to it. So here it is! Our DIY IKEA Kura bed hack. I love it because it looks like a little house, and it gives you all kinds of opportunities for playing and decorating.

Materials

   IKEA Kura bed

   sander

   wood stain and seal (optional)

   2×2 pine boards

   miter saw

   screws

   drill

   pencil

   ruler

Make Time: 4 Hours

Step 1: If you like, sand, stain, and seal all wood portions of the bed. Henry’s room has dark wood in it so we sanded the wood to match.

Step 2: Build the bed according to the instructions on the packaging. Just a note about this bed: It’s actually reversible. For now, the mattress is on the lower section and the rails are on the top. But when the kid gets older you can flip it over so it’s a loft bed, with the mattress on the top and space underneath. We made our hack so that when the time comes, it’s completely removable.

Step 3: Build the “roof” of your house. Cut one piece of pine board to the length of the bed. This will be the peak. Cut another piece to the height that you’d like the roof. You won’t end up using this piece; it’s just for measuring.

Step 4: Lay the long piece (A) on the floor and the height piece (B) perpendicular to it, in the exact center. Then lay another piece of board (C) under the two, creating a triangle. Trace two lines on this board, extending from piece A and piece B. This will be the angle that you’ll need to cut on either end with your miter saw. Do this with three more boards. You can just set the angle on your miter saw and cut four boards total.

Step 5: Drill pilot holes slightly smaller than the size of your screws through the diagonal pieces (all piece C’s) and into piece A where they will connect. Screw all pieces together.

Want to know more ?

Download this application now and get what you want here. worth to try and you will like it.

simply share through any social media platforms. thank you for downloading. please enjoy and give us any feedback.

What's New in the Latest Version 7.1